Maytronics Power Supply Not Turning On

Check that the power supply is plugged in and turned on check that the power cable is securely connected all the way into the power supply turn the power supply off.

Maytronics power supply not turning on.

Open the impeller cover and check that nothing is trapped in the impeller. As a result that light shouldn t turn on again until the filters begin to fill up or are full. Press the on button the leds will turn on and the robot will start to operate. If the outlet is receiving power.

Ensure the power outlet is functioning properly and that it has not tripped the breaker in the fuse box. Check power to the socket and reconnect pool cleaner. Going to start a thread to see if anyone has attempted this. It is possible all the brains of direction and what functions to perform are controlled by the power supply box in that case it most likely would not work.

You ll know the app is connected if the power supply buttons are overridden in disable mode. Unplug the blue cable from the power supply unit psu and turn it on. What about damaged filters. Wait 30 seconds then turn it back on.

Power supply not rated yet our power supply for our dolphin 3001 will not turn on. Plug the power supply into an electrical outlet. After 1 min connect your smartphone to wifi. Open the impeller cover and check that nothing is trapped in the impeller.

Ensure the power outlet is functioning properly and that it has not tripped the breaker in the fuse box. In essence what you ve just done is zero out the sensor. If the psu turns on and the lights stay on the problem is not with the psu. See the relevant section below for more details on each program.

Take it to your local dealer for further testing or call maytronics customer service. Turn the power supply off. The pool cleaner moves but. Wait 30 seconds then turn it back on.

A known exception the robo kleen power supply puts out about 30 volts a c you read correctly a c. Wait 30 seconds then turn it back on. Unplug the power supply. We had been using it then i shut it off to clean out filter and it will not come back on.

Turn the power supply off. Close the unit casing turn it on and let it run. If no program is selected the robot will perform a single cleaning cycle. Output voltage should be about 38 volts d c.

Are you happy with what you learned here. To check your maytronics diagnostic power supply use a multimeter set to 200vdc. There may be a problem with the blue cable or the dolphin cleaner itself. We had been using it then i shut it off to clean out filter and it will not come back on.

Pair via bluetooth to your dolphin not a neighbor s. Check the label on your transformer for voltage output and type.